Table of Contents
Advertisement
3
Help with the appliance
H e l p w i t h t h e a p p l i a n c e
Faults
The appliance will not
start.
Creasing.
Water is leaking out.
Programme duration dis-
played changes as dry-
ing progresses.
Laundry is not dried
properly or is still too
damp.
The programme will not
start
Cause/remedy
Check the mains plug and the fuses.
Load exceeded or incorrect programme selected for a type of fabric. All the
■
required information can be found in the programme table.~ Page 23
Remove laundry from the drum as soon as the drying programme has fin-
■
ished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
■
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
~ Page 43
If the optional drain hose* is installed, make sure that the drain hose is cor-
■
rectly connected. ~ Page 38
Not a fault. The moisture sensor measures the residual moisture in the laundry
and adjusts the programme duration (with the exception of timed programmes).
After the programme has ended, warm laundry feels damper than it actu-
■
ally is. Spread out the laundry and let it cool down.
Adjust the drying time or increase the degree of dryness. This will extend
■
the drying time but the temperature will remain the same.
Select a timed programme to add extra drying time for laundry that is still
■
damp.
Select a timed programme for a small load.
■
Do not exceed the maximum load for a programme.~ Page 23
■
Clean the moisture sensor in the drum. The sensor may become covered in
■
a fine layer of limescale or detergent and care product residue, which then
impairs its performance.~ Page 42
Drying has been interrupted as a result of a power cut, because the conden-
■
sation container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips.~ Page 27
Make sure that:
The door is closed.
■
w 3 sec (Child lock) has been deactivated
■
You have pressed I (Start/Pause)
■
Note:
If the programme has been delayed by setting B (Ready in), the pro-
gramme will start later.
Help with the appliance
en
53
Advertisement
Table of Contents
