Advertisement
T
B
echnical
ulletin
PAGE: 3/6
Reissued: 3-Dec-03
Model:
Date:
No.:
Model U-P1
3-Feb-03
RG071004d
Symptom Corrected
Version
2. Existing SP mode subdivided:
V1.47A
SP3-920 has been subdivided as follows to enable separate
lubrication time control for 1C vs. 2C/3C/4C.
SP3-920-001 (Lubrication Cleaning Time: - 1C)
[0 ~ 100 / 50 / 1% /step]
SP3-920-002 (Lubrication Cleaning Time: - 2C/3C/4C)
[0 ~ 100 / 100/ 1% /step]
3. Carryover SP modes from Copier firmware – Currently
UNUSABLE
The following are the SP modes carried over from the Copier
firmware which will therefore appear on the display, as the printer
firmware is created using the Copier firmware base. Please note
that currently these SP modes should not be used on the printer,
therefore please DO NOT CHANGE their values.
SP2-951-001 (Image Position Adjustment): DFU
0: New PCU: ITB cleaning blade:
1: Old PCU: No ITB cleaning blade (Default):
SP2-950 (Start Registration Adjustment):
SP2-921-001 (ITB Cleaning Clutch OFF Mode): DFU
0: New PCU: ITB cleaning blade
1: Old PCU: No ITB cleaning blade (Default)
SP2-920-001 (ITB Cleaning Clutch OFF Time)
[-500 ~ 500 / 0 / 10 /step]
SP2-924-001 (ITB Cleaning Clutch Off/On – Time)
[100 ~ 500/ 300 / 10ms /step]
SP2-924-002 (ITB Cleaning Clutch Off/On – Number)
[0 ~ 5/ 0 / 1 /step]
NOTE: Along with this BICU version, be sure to update the main
unit controller firmware to v2.29 or later.
Advertisement
