Advertisement
RG071002
Model:
Model U-P1
Subject:
Service Manual
From:
Technical Services Sec. Service Planning Dept.
Troubleshooting
Classification:
Mechanical
Paper path
Other (
Please apply the following correction to your Model U-P1 Service Manuals.
Page 3.23
The orientation of both bearings in the illustration below should be reversed.
Note: This is an illustration correction only. The procedure itself is unchanged.
[C]
[A]
T
echnical
Part information
Electrical
Transmit/receive
)
[B]
B
ulletin
Date:
20-Jan-03
Prepared by:
Action required
Service manual revision
Retrofit information
3.8.2 TRANSFER ROLLER
1. Brace [A] (Screwx1)
2. Guide [B]
Note: To remove the screws, turn the
roller unit on its pivot.
3. Transfer roller [C]
(E-ringx2, Bushing x2, Bearingx2)
PAGE: 1/1
No.:
RG071002
Y.Urushihara
Advertisement
