Advertisement
Reissued: 29-Jan-04
Model:
Model U-P1
Main Unit Controller
1. "Paper End" is sometimes not displayed, or the machine sometimes
freezes up with the display "Processing..." while in the Paper End
condition if the operator has selected Custom Size and Auto Paper
Tray Selection.
2. Modified in accordance with BCU v1.48d modification. For details,
please see RTB #RG071004e.
Note: Along with this main unit controller version, be sure to update the
BICU firmware to v1.48d or later.
SC687 occurs with multi-prints onto B4 (B/W).
1.
Modified in accordance with BCU v1.47a modification. For details,
2.
please see RTB #RG071004d.
NOTE: Along with this main unit controller version, be sure to update the
BICU firmware to v1.47a or later.
Merged PCL job cannot print (TechMail#TS030100).
1. The following SP modes have been added.
For details, please refer to BICU firmware release note RB051004c: BICU
v1.44A.
SP2-400-008: Cleaning Bias LL1: OPC lubrication time
SP2-401-008: Cleaning Bias LL2: OPC lubrication time
SP2-402-008: Cleaning Bias NN1: OPC lubrication time
SP2-403-008: Cleaning Bias NN2: OPC lubrication time
SP2-404-008: Cleaning Bias HH: OPC lubrication time
[0 to 2000/ 1400 / 10 Volt/step]
2. Minimum value changed for SP2-941-01, -02 (OPC lubrication time).
Minimum increased from 0 to 6:
SP2-941-01: Job End: [6 ~ 30 / 14 / 1 s/step]
SP2-941-02: OPC Lubrication Interval: [6 ~ 60 / 10 / 1 s/step]
NOTE: Along with this main unit controller version, be sure to update the
BICU firmware to v1.44A or later.
T
echnical
Symptom Corrected
B
ulletin
Date:
3-Feb-03
PAGE: 3/12
No.:
RG071003e
Version
V2.30
V2.29
V2.28.2
V2.28
Advertisement
