Advertisement
Reissued: 19-Mar-03
Model:
General RTB
RTB Reissue
The items in bold italics have been corrected or updated.
Subject:
Service remarks at installation
From:
Technical Service Sec. Service Planning Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Other (Specification change)
Please note the following change in counter specification. Although a production line
modification will not be applied to some products, the action described in 4. Important
Notes for Installation below must be taken for all products at installation.
Overview:
Electronic counters will now be set to 0 when released from the factory, instead of being
set to a negative value.
Background:
Previously, counters were set to a negative value when shipped from the factory, and later
set to "0" at installation, following installation test copies/prints. However this may cause
confusion among some customers as to why the counter value at the commencement of
the contract is "0", even though some installation test copies have already been made.
Details:
1. Specification Change
• The initial value of the electrical counter is negative when products
Current
are shipped from the factory.
Note: After making test samples at installation, the negative counter
value can be set to "0" with SP mode.
• The initial value of the electrical counter is "0" when products are
New
shipped from the factory.
Note: After making test samples at installation, the (positive) counter
value cannot be set back to "0" with SP
T
B
echnical
Part information
Electrical
Transmit/receive
Specification
ulletin
Date:
4-Feb-03
Prepared by:
T. Itoh
Action required
Service manual revision
Retrofit information
mode.
PAGE: 1/4
No.:
RGene013b
Advertisement
