Advertisement
Important: In the next step, be sure and lift up the shaft slowly and gently. If it is lifted up
too quickly or with too much force, the fusing lamp will be damaged.
6. Lift up the shaft [A] very gently, just enough so that the lower pressure spacer can be
inserted. While holding the shaft up, insert the lower pressure spacer (B0514371)
between the pressure side plate [B] and lower cover.
Note: Insert the spacer so that the positioning projections can pass through the hole
and cut-outs in the spacer (see the illustrations below).
A
Lift up
slightly and
gently.
Bird's eye view of Fig.1 above:
B
Positioning
projections
Lower pressure spacer
B0514371
Projections should
pass through holes
and cut-outs.
8
Advertisement
