Reattaching The I/O End Cap - Cisco 3200 Series Hardware Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Reattaching the I/O End Cap

Step 1
Step 2
Step 3
Step 4
Step 5
OL-15983-01
Get user manuals: See SafeManuals.com
To reattach the I/O end cap, follow these steps:
Align the guide pins of the I/O end cap with the front of the extrusion. (The antenna end cap does not
have guide pins. The extrusion does not have holes for the guide pins in the back of the extrusion.)
Figure 2-15 shows the I/O end cap.
Figure 2-15 I/O End Cap
1 power cables
3 I/O end cap groove and gasket
Fit the I/O transition board with the wiring card.
Verify that the gasket is fully centered in the groove (shown in
Press the I/O end cap in place.
Use a 3/8-inch socket wrench to secure the I/O end cap with (4) 1/4-20x1 1/4-inch- long bolts. The
torque range for the I/O end cap bolts is from 58 to 68 in-lb.
1
3
2
2 I/O transition board
Figure 2-4 shows the I/O transition board.
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
Figure 2-4).
2-17