Cisco 3200 Series Hardware Upgrade Manual page 48

Card Replacement Process
Cisco 3200 Series Router Hardware Upgrade Guide
3-12
Get user manuals: See SafeManuals.com
Figure 3-12 1-WMIC Configuration
1
1 Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
3 Connect the FESMIC 10-pin FE3X cable to
WMIC 1.
For a 2-WMIC configuration, connect the cables to the wiring card as shown in
Figure 3-13 2-WMIC Configuration
1
5
1 Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
3
Connect the FESMIC 10-pin FE3X cable to
WMIC 1.
5
Connect the WMIC 2 console port to port J2
on the wiring card, using a 20-pin cable.
Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
2
3
4
2 Connect the FESMIC 10-pin FE2X cable to
port J4 on the wiring card.
4 Thread the FE extender cable under the card
stack to the antenna end cap side.
2
3
4
2 Connect the FESMIC 10-pin FE2X cable to
WMIC 2.
4
Thread the FE extender cable under the card
stack to the antenna end cap side.
Figure 3-13.
OL-15983-01