Removing The I/O End Cap - Cisco 3200 Series Hardware Upgrade Manual

Card Replacement Process

Removing the I/O End Cap

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco 3200 Series Router Hardware Upgrade Guide
3-4
Get user manuals: See SafeManuals.com
To remove the I/O end cap, follow these steps:
Use a 3/8-inch socket wrench to loosen the four 1/4-20 bolts on the end cap using a torque range of 58
to 68 in-lb.
If a protective end cap cover (see
Note
ports on the I/O end cap, loosening the four 1/4-20 mounting bolts on the protective end cap
allows you to remove the protective end cap and the I/O end cap from the extrusion.
Carefully pull off the end cap enough to give you enough room to disconnect the power cable.
shows the cables.
Figure 3-3 Disconnecting the Power Cable
6
1
GE 0
3 FE extender cable
5 USB cable
Disconnect the power cable from the end cap.
Slowly pull out the USB, FE 0, FE 1, GE 0, and GE 1 cables (which you already disconnected from the
card stack when you removed the antenna end cap) from beneath the card stack to free up the I/O end cap.
Place the end cap on your work surface.
Chapter 3
Figure 2-16) is used to provide weatherproof protection for the
1
2
5 4
3
2
4
6
Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
GE 1
FE cable
Power cable
Figure 3-3
OL-15983-01