Reattaching The I/O End Cap - Cisco 3200 Series Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Reattaching the I/O End Cap

To reattach the I/O end cap, follow these steps:
Align the guide pins of the I/O end cap with the front of the extrusion. (The antenna end cap does not
Step 1
have guide pins. The extrusion does not have holes for the guide pins in the back of the extrusion.)
Figure 2-15
Figure 2-15
1
3
Fit the I/O transition board with the wiring card.
Step 2
Verify that the gasket is fully centered in the groove (shown in
Step 3
Press the I/O end cap in place.
Step 4
Use a 3/8-inch socket wrench to secure the I/O end cap with (4) 1/4-20x1 1/4-inch- long bolts. The
Step 5
torque range for the I/O end cap bolts is from 58 to 68 in-lb.
OL-15983-01
shows the I/O end cap.
I/O End Cap
power cables
I/O end cap groove and gasket
1
3
2
2 I/O transition board
Figure 2-4
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
shows the I/O transition board.
Figure 2-4).
2-17