Table of Contents
Advertisement
Figure 14 Drilling holes in the wall
3.
Insert a screw anchor into each hole, and tap the screw anchor with a rubber hammer until it is
all flush with the wall surface, as shown in
Figure 15 Hammering the screw anchor into the wall
4.
Thread the M3 × 23.5 security screw through the security hole in the mounting bracket. Make
sure the screw does not block the keyhole slot.
Figure 16 Inserting the security screw
5.
Insert the screws through the installation holes in the mounting bracket into the holes in the
wall. Fasten the screws to secure the mounting bracket to the wall, as shown in
Figure
15.
6
Figure
17.
Advertisement
Table of Contents
