General Information; Manufacturer Identification Information; Machine Identification Rating Plates And Data; Declarations - Ecotech Italia DCS-BT Series Use And Maintenance Instruction Manual

2 GENERAL INFORMATION
2.1 MANUFACTURER IDENTIFICATION INFORMATION
ECOTECH ITALIA
s.r.l. Via Copernico 85 – 47122 Forlì (FC) ‐ Italy
Tel. 0039 (0)543 774314 Fax. 0039 (0)543 778658 E‐mail. info@ecotechitalia.com
AFTER SALES SERVICE/SPARES:
found at Resellers or Authorised Service Centres: see the list on www.ecotechitalia.com.
2.2 MACHINE IDENTIFICATION RATING PLATES AND DATA:
Each machine is identified by a CE plate on which information concerning the machine has been printed indelibly.
For any communication with the manufacturer or the service centres always cite the following references:
The location of the plate may vary from machine to machine.
2.3 DECLARATIONS
The machine has been manufactured in conformity with the European Community Directives pertinent and applicable at the
moment of its release on the market.
2.3.1 Declaration of Conformity
THE MANUFACTURER
ECOTECH ITALIA s.r.l. via Copernico, 85 47100 Forlì FC ‐ ITALY, declares, under its exclusive responsibility, that the product:
Lawn mower brush‐cutter/Lawn mower for edges – Series DCS/BT– Model: 60 ‐ 60 Traction / 60 SwingTop
Type:
Conforms to the following EU regulations

Machine Directive (Directive 2006/42/EC) and to all national provisions for implementation;

European Directive 2000/14/EC and later amendments, concerning environmental noise emissions of machines and equipment intended for
use outdoors.
Harmonised standards applied:
UNI EN ISO 3744:2009; UNI EN ISO 20643:2008; UNI EN ISO 12100‐1:2009; UNI EN ISO 12100‐2:2009; UNI EN ISO 14121‐1:2007
The person authorized to compile the Technical Manufacturing File is Mr. Roberto Romboli at ECOTECH ITALIA via Copernico, 85 47100 Forlì FC – ITALY.
The Technical Manufacturing File required by the Machine Directive 2006/42/EC is kept on file at the company offices.
All of the instructions on use found in the manual supplied with the machine must be complied with as well as all of the safety and accident prevention
standards in force in the country of operation. The product bears the CE Mark.
Date:
Jan. 03, 2011
Table 2‐1: Extract of the Declaration of Conformity
DECLARATION OF CONFORMITY
(Annex II‐A Dir. 2006/42/CE)
Series DCS/BT
Figure 2‐1 CE plates
Year of Manufacture:
Signature:
2011