Scrapping; Safety; General Warnings; Use Restrictions - Ecotech Italia DCS-BT Series Use And Maintenance Instruction Manual

4.4 SCRAPPING
Proceed with the disassembly of the machine dividing its parts based on the materials with which they were manufactured.
Follow the waste management and disposal standards in force.
5 SAFETY
5.1 GENERAL WARNINGS
Inside of this manual and on the machine there are indications and printed messages together with the danger symbol shown
below that indicate potential hazard. It would be best, therefore to pay close attention to what is shown or written in order to
ensure greater safety for the operator and anyone else who might be in the operational range of the machine.
Read this manual before using the machine. Only the instructions found in this manual will assist you in using
the machine safely and efficiently.
Safe usage is only the result of proper operation of the machine, in compliance with the standards and
limitations described in this manual. Therefore, you must know and comply with all safety warnings in this
manual and those relative to the proper operation of the machine.
5.2 USE RESTRICTIONS

Do not allow anyone to use this machine without having first read and understood this manual.

Keep away from children.

Do not wear baggy clothing, which may become entangled in the machine's moving parts.

Work only in daylight or with sufficient artificial lighting.

Transport of persons, animals or loads on the machine during its operation or transport is severely prohibited.

Reduce the forward movement speed when working on a slope and when turning, so as to avoid any possibility of
losing control of the machine.

Pay close attention when in the vicinity of any trench, hummock or dip.

Turn off the motor before undertaking any procedure on the machine.

Never work underneath the machine or under raised parts of the machine that have not been safely supported into
position with blocks, and always with the motor turned off.

When working on a slope always work transversally, never directly upwards or downwards.

Keep a safe distance from electrical wires and other obstacles. Contact with electrical wires or conductors can cause
electrocution and death.

It is obligatory that the operator, in order to avoid being struck by objects projected from the machine, wear:
FULL FACE PROTECTION MASK
o
COVERALLS
o
SAFETY BOOTS
o
GLOVES
o
HAT
o
5.3 DANGEROUS ZONES
Cutting components;
Movement transmission components;

Never stand in front of the operating machine: there is the danger of the projection of objects and debris.

Always keep at least 15 metres distance from the operating machine: in the event of supervision or observation keep to
the side and at a safe distance.
5.4 SAFETY DEVICES
Relative to the dangerous areas identified in the preceding paragraph, protective housings have been installed both for the
cutting components and the transmission.
1 – Cutting blades housing
2 – Transmission housing
Figure 5‐1 Transmission and cutting blades housings
DO NOT TAMPER WITH OR REMOVE THE SAFETY DEVICES.