Table of Contents
Advertisement
5.5
SIGNS
See Table 1‐3: Symbols concerning safety for the meaning of the symbols.
ATTENTION!!! This machine is equipped with sharp cutting components; therefore keep hands and feet a
safe distance away from these. Never perform any procedures on the machine whilst it is running.
It is recommended to not work in areas with gravel, rocks and/or foreign objects on the ground that may be projected by the
cutting blades making it extremely dangerous for persons or things in the vicinity of the running machine. Keep all personnel at
least 15 metres away from the machine. The operator shall always wear a protective face mask and as necessary rubber boots
as well.
ATTENTION!!! Always keep the hands at a safe distance from the oscillating mechanism on the machine as it
can easily crush the fingers.
APPLICATION OF THESE REGULATIONS IS NOT A WASTE OF TIME!
THESE REGULATIONS CONTRIBUTE TO KEEPING PERSONS AND THINGS FROM IRREPARABLE HARM AND
ENSURE OPERATOR SAFETY.
5.6
RESIDUAL RISKS
Noise: always wear ear protection.
It is recommended that one take regular breaks during work time. Do not use the machine for more than 8 hours in a day.
6
MACHINE USE
Dear customer, we thank you for the trust you have given ECOTECH ITALIA. We are confident that use of this new machine will
fully fulfil your requirements.
For the purpose of obtaining optimum application and efficient maintenance of the machine over time, please read all of the
directions and warnings described in this booklet, which must always be kept together with the machine.
BEFORE STARTING UP THE MACHINE READ THE USE INSTRUCTION MANUAL THOROUGHLY!
6.1
ADJUSTMENTS
Model
Adjustment
BT 60
Cutting
With a tubular socket wrench of size 13, loosen the screw under
height
the cup (Figure 6‐1), move one or both of the blocks from the top
plate to the bottom of it (fig.6‐2), then screw the whole thing and
tighten the screw.
Figure 6‐1: cutting head
ON TOP OF THE MACHINE THIS FIGURE IS FOUND:
Figure 5‐2: Adhesive label located on the machine
DCS 60
DCS 60 Traction
Figure 6‐2: cutting heights
DCS 60 Swing Top
Advertisement
Table of Contents
