Table of Contents
Advertisement
4
Installation
A: Camera Ethernet Connector
B: O-ring
C: Barrel
D: Stopper
E: End Cap
10.1.
Fit the o-ring around the camera Ethernet connector.
10.2.
Feed the Ethernet extension cable through the end cap and the barrel then connect
the cable to the camera Ethernet connector.
10.3.
Twist the barrel securely onto the camera Ethernet connector. The o-ring becomes
compressed when the seal is properly tight.
10.4.
Split the stopper to wrap it around the cable between the barrel and end cap as shown
above.
10.5.
Push the stopper toward the barrel until it is underneath the teeth at the end of the
barrel.
10.6.
Twist the end cap clockwise to secure it onto the barrel. The stopper becomes com-
pressed and will stick out of the end cap slightly when the seal is properly tight.
11. Pull the connection cables through the wall mount and mounting surface.
12. Attach the flat washers (x4) to the mounting screws (x4).
#LX400116; r. 4.0/60127/60127; en-US
11
Advertisement
Table of Contents
