Table of Contents
Advertisement
Available languages
Available languages
Rear panel
1
2
No. Name
USB-C
1
HOST
2
HDMI IN
3
HDMI OUT
4
HDBT
5
AUDIO
6
Dry
contact
7
closure
RS232
8
Upgrade
9
TCP/IP
10
DC 24V
11
EN
3
4
5
Description
1 x USB-C input supports DP Alt mode and PD 3.0
(PD support requires to install the PSU locally.)
1 x USB-B 3.0, connect to HOST devices (e. g. laptops)
1 x HDMI input
1 x HDMI loop output
1 x HDBT output, yellow LED is constantly on when TX and
RX are connected. Green LED is always on when the signal
is with HDCP, flashes when the input signal is without HDCP
1 x 5-pin balanced audio output of de-embedded audio
signal from the active input
> Input 1: USB-C
> Input 2: HDMI
> SM: Switch the source
> BO: Black screen on all outputs.
> Ground: Common ground for SM and BO
LOCAL: Connect a media controlling system to control the
transmitter
PASS: Bidirectional passthrough transmission to receiver
1 x Press and hold for 3s to enter the upgrade mode, when
the power LED starts flashing you can upgrade the firmware
through the serial port. Press the button again to exit the
upgrade mode.
1 x RJ45, access on WebUI and control device via TCP/IP
Power input (if the PSU is attached to the receiver, USB-C
PD function isn't avialable)
6
7
8
10
11
9
29
Advertisement
Table of Contents
