Table of Contents
Advertisement
Steps
1. Connect the cable to the internal PERC card.
Figure 50. Connecting the cable to internal PERC riser
2. Holding the blue touch points, align the slot on the internal PERC riser to the guide on the system board.
3. Insert the internal riser card's edge connector firmly into the system board connector until the riser is fully seated.
4. Lift the plunger to lock the riser in place.
Figure 51. Installing internal PERC riser
5. Connect the cables to the backplane and then route the cables to the cable guiding latch to close the latch.
Next steps
1.
Install the air shroud.
2. Follow the procedure listed in
After working inside your
system.
Installing and removing system components
59
Advertisement
Table of Contents
