Removing The M.2 Ssd Module - Dell PER4402A Installation And Service Manual

Figure 74. Installing the M.2 SSD module
Next steps
1. Install the BOSS card.
NOTE: The procedure to install the BOSS card is similar to the
2. Install the air shroud..
3. Follow the procedure listed in

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the
Steps
1. Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
2. Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
After working inside your
Safety instructions
Before working inside your
removing an expansion
system.
system.
removing an expansion
Installing and removing system components
card.
card.
79