Figure 20. Inside the system
1. left control panel cable cover
3. backplane expander board
5. air shroud
7. power interposer board
9. low profile expansion riser 1
11. processor blank
13. air shroud
15. left control panel cable cover
Backplane cover
Removing the backplane cover
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the system
cover.
Steps
1. Slide the backplane cover in the direction of the arrows marked on the backplane cover.
2. Lift the backplane cover away from the system.
Safety
instructions.
Before working inside your
2. hard drive backplane
4. cabling latch
6. intrusion switch
8. internal expansion riser
10. low profile expansion riser 2
12. heat sink
14. cooling fan blank
16. information tag
system.
Installing and removing system components
31