Table of Contents
Advertisement
Figure 53. Installing PERC card into internal PERC riser
Next steps
1.
Install the internal PERC riser.
2.
Install the air shroud.
3. Follow the procedure listed in
Expansion cards and expansion card risers
NOTE:
A System Event Log (SEL) event is logged if an expansion card riser is not supported or missing. It does not prevent
your system from turning on. However, if a F1/F2 pause occurs, an error message is displayed.
Expansion card installation guidelines
Depending on your system configuration, the following PCI Express (PCIe) generation 3 expansion cards are supported:
Table 22. Expansion card riser configurations
Expansion card riser
LOM riser
Right riser
Right riser
PCIe passive bridge
Internal riser
Left riser
NOTE:
The expansion card slots are not hot-swappable.
After working inside your
PCIe slots on the riser
Slot 1
Slot 2
Slot 2
Slot-integrated
Slot-integrated
Slot 3
system.
Height
Mezz type
Low Profile
Full Height
Low Profile
Low Profile
Low Profile
Installing and removing system components
Length
Mezz type
Half Length
Half Length
Half Length
Half Length
Half Length
Link
x8
x16
x16
x8
x8
x16
61
Advertisement
Table of Contents
