Table of Contents
Advertisement
Infrared Port Module Connector (J2 pin6-10)
The system board provides a 5-pin infrared connector-R1
for an optional wireless transmitting and receiving module.
Pin 6 through 10 are Transmit, GND, Receive (low speed),
Receive (high speed), and Vcc, respectively.
J2 pin12, 13: PWR Switch
Power Switch: Toggle this pin for turning on/off of the
Power supply (for ATX power only).
SLEEP Switch (J2 pin14, 15)
Toggle this jumper forces the system to sleep and the system
won't wake up until the hardware event is coming. (The
BIOS Power Management setting must be Enabled.)
Speaker Connector (J1 pin1-4)
The speaker connector is a 4-pin connector for connecting
the system and the speaker. (See the following drawing for
jumper position.)
Reset Switch (J1 pin5, 6)
The system board has a 2-pin connector for rebooting your
computer without having to turn off your power switch.
This prolongs the life of the system's power supply.
Power LED and Keylock Switch (J1 pin8-12)
The keylock switch is a 5-pin connector for locking the
keyboard for security purposes. (See the following drawing
for jumper position, and pin1~3 is connected to power LED
and pin 4~5 is connected to keylock switch.)
9
Advertisement
Table of Contents
