F D C : F L O P P Y D R I V E C O N N E C T O; Ide1/Ide2:Primary/Secondary Ide Connectors; Infrared Port Module Connector (J2 Pin6-10); Sleep Switch(J2 Pin 14-15) - SOLTEK SL-63AV Users Manual And Technical Reference

FDC:Floppy Drive CONNECTOR
The system board has a 2x17-pin floppy drive connector,
FDC. Connect one end of a floppy drive cable to this
connector and the other end to a floppy drive.
IDE1/IDE2: Primary/Secondary IDE Connectors
The system board has a 32-bit ENHANCED PCI IDE
Controller that provides for HDD connectors,
IDE1 (primary) and IDE2 (secondary).
IDE LED Activity Light: (J2 pin1-4)
This connector connects to the hard disk activity indicator
light on the case.

Infrared Port Module Connector (J2 pin6-10)

The system board provides a 5-pin infrared connector-R1
for an optional wireless transmitting and receiving module.
Pin 6 through 10 are Transmit, GND, Receive (low speed),
Receive (high speed), and Vcc, respectively.
PWR Switch (J2 pin12, 13)
Power Switch: Toggle this pin to turn the power supply
on/off (for ATX power only).
SMI Switch (J2 pin14, 15)
Toggle this jumper forces the system to sleep. The system
won't wake up until the hardware event is coming. (The
BIOS Power Management setting must be Enabled.)
13