Ide Primary; Master/Slave Pio; Ir Function Duplex; Onboard Parallel Port - SOLTEK SL-65D User Manual

IDE Primary

Master/Slave PIO

IDE Secondary
Master/Slave PIO
On-Chip Primary/ Enabled: (default)Turn on the
Secondary PCI IDE
Onboard FDC
Controller
Onboard Serial
Port 1
Onboard Serial
Port 2
UART 2 Mode
IR Function
Duplex
Onboard Parallel
Port
32
Choose Auto (default) or Mode 0~4.
The BIOS will detect the HDD Mode
type automatically when you
choose Auto. You need to set to a
lower mode than Auto when your
hard disk becomes unstable.
onboard IDE function.
Disabled: Turn off the onboard IDE
function.
Choose Enabled (default) or
Disabled. Choose Disabled when
you use an ISA card with FDD
function, or , choose Enabled to use
the onboard FDD connector.
Choose Auto (default), 3F8/IRQ4,
2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, or
Disabled. Do no set port 1 & 2 to
the same value, except when setting at
Disabled.
Choose Auto (default), 3F8/IRQ4 ,
2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, or
Disabled.
Choose Standard (default), HPSIR, or
ASKIR.
Choose Half or Full
Choose the printer I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5, Disabled