Mounting The Everywhere Trolley; Safety; Fitting The Power Source To The Trolley - Fronius TransPocket 4000 CEL Operating Instructions Manual

Mounting the Everywhere trolley

Safety

Risk of electric shock.
If the device is plugged into the mains during installation, there is a high risk of
serious injury and damage to property.
▶
▶
Fitting the power
source to the
trolley
Inserting the locking devices
Power source and trolley
Positioning the shims and wing nuts
86
WARNING!
Only carry out work on the device if the mains switch is in the "O" position.
Only carry out work on the charger when it has been disconnected from the
mains supply.
(1) (1)
X
(2) (3) (2)
Insert the locking devices (1) in the
1
holes on the trolley base
Position the locking devices (1) at
2
an angle as far as they will go
IMPORTANT! When positioning the
power source vertically, make sure that
the mains cable is not kinked, pinched
or strained.
Carefully position the power
3
source vertically at the rear
Carefully position the trolley verti-
4
cally at the rear
Push the trolley against the power
5
source so that the trolley and the
power source are centrally aligned
opposite each other
Position the shims (2) on the six
6
threaded bolts and slightly tighten
wing nuts (3)
(3) (2) (3)