Fronius TransPocket 4000 CEL Operating Instructions Manual page 81

(1) Parameter selection button
For selecting the following welding parameters
-
Welding current (6)
-
Arc-force dynamic (7)
(2) The "+" button ... increases the selected parameter value
(3) The "-" button ... decreases the selected parameter value
IMPORTANT! Regardless of the service codes listed in the "Troubleshooting"
section, the following service codes may be displayed on the TP 08 remote con-
trol:
Service code: -oFF
Cause: Poor contact with the workpiece
Remedy Satte Verbindung zum Werkstück herstellen
Service code: -E62-
Cause: Overheating of TP 08 remote control
Remedy: TP 08 abkühlen lassen
While the power source or other system add-on displays a service code, the TP
08 remote control is deactivated.
81