Initial Loading Sequence; Menu Navigation Controls; Set The Date And Time - Lorex L19LD800 Series Quick Start Manual

STEP 1 - SET UP YOUR MONITOR FIRST
CONTINUED
7
8
navigatiOn &
Menu
9
DATE / TIME SETUP
SETUP
DATE 2007/09/16
TIME 19:08:13
TIME ZONE (GMT-05:00) Eastern Time
DST OFF
FORMAT
DATE YYYY/MM/DD
TIME 24H
TIME SYNC
INTERVAL OFF
SERVER
www.lorexcctv.com
a
b
enter
SYNC

INITIAL LOADING SEQUENCE

the unit will automatically begin loading when power is connected to
the system.
a. during the loading sequence, the system will perform a Hard drive and
firmware check and the screen will display the text message
cHeck".
b. Once the system checks are completed, the screen will display the text
message "initiaLiZing systeM"
c. the unit will initially load to a split screen view, displaying all 8 cameras
(if available) and a system legend in a 3x3 screen view.

MENU NAVIGATION CONTROLS

• Menu Button – accesses the setup menu, and returns to previous
menu options.
• navigation controls - Move up/down/Left/right.
• enter Button - press this button to select and change the values in a
menu option.
SET THE DATE & TIME
click the Menu button on the front panel of the Monitor (or the
remote controller) to enter the Main Menu. from the Main Menu
move to systeM and press the enter button to go to the date/tiMe
menu to activate menu options.
nOte: after you see all four (4) camera images
on your monitor screen, remove the protective
film from camera(s) and monitor screen.
Congratulations! You have completed Step 1
successfully. You can now view, record and
playback images on your monitor.
"systeM
before completing the loading process.
nOte: this may take up to 60
seconds. please wait until the
c
system completes loading.
Make sure that
the Date and Time
are set prior to
recording.
Page:
L19LD800 SerieS QSG_eN_r2