Sanremo YOU Instruction Booklet page 22

YOU
Connect the intake pipe (2) to a softener (4) with the
impurity filter (3) between them.
- Before the softener (4), install a shuttering tap (5)
to separate the water system from the machine.
1
WARNING: If the line pressure
exceeds 58 PSI, install a pressure
reducer. Only supply with cold
water.
The equipment is to be installed
with adequate backflow protection
to comply with applicable federal,
state, and local codes. For the water
mains connection use hose-sets
supplied. When you need to replace
the hose-sets you must only use a
new hose-sets and the old hose-sets
should not be reused.
2
4
5
3
Tank
To fill the tank, lift the lid and pour water until the
maximum level is reached.
The machine is set to tank mode by default. To
switch from tank mode to mains mode, remove the
cup warmer and use a slotted screwdriver to turn the
metal lever clockwise as shown in the image.
IMPORTANT: The following must be
performed only by a specialised
and authorised technician.
For connection to the water mains,
use the pipes set supplied. Once
worn, it must only be replaced with
a new set of pipes. The old pipe set
must not be reused.
22
Connections