Safety* Explanation of signal CAUTION Do not operate equipment without words for safety wearing personal protective gear. The assembly must be installed, maintained Wear eye protection. Protective and repaired exclusively by persons familiar equipment such as dust mask, non-skid with the instructions.
Page 6
Lubricant operating pressure (psi) Lubricant Reservoir Lubricant Type of Ratio output capacity inlet outlet System Minimum Maximum Recommended : . in ) lbs ( in in NPT (F) in NPT (F) SL- psi with psi air psi with psi air psi with psi air :...
To prime system Supply lines After pump reservoir has been filled with recommended lubricant, turn vent plug counter-clockwise one complete turn and operate pump until lubricant flows freely from opening in vent plug to expel air pock- ets trapped between the pump and the sup- ply line connection.
Page 8
Fig. Model Low level cut-off kit may be used as an alarm or signal device when lubricant drops below an acceptable level. ) Torque to ft.lbf ( Nm) ) Air inlet ) required. ) Flow ) ...
Page 9
Fig. Model air operated single stroke grease pump (393.7 mm) (55.6 mm) (36.5 mm) (27 mm) ∅ (13.5 mm) (89 mm) (27 mm) (147 mm) ...
Page 10
Fig. Line check in NPTF in NPTF Inlet ) Outlet ) What to do if: To clean line check 83114 Pump loses prime Check lubricant supply. Remove Check and examine packing for presence of foreign particles. If packing is damaged, replace ...
Page 11
Service parts Item Description Part number Quanity Item Description Part number Quanity Tie rod Pump tube Cylinder cap YE O-ring (Nitrile) ) Piston nut Bushing and plunger ...
Need help?
Do you have a question about the LINCOLN D Series and is the answer not in the manual?
Questions and answers