IO-Link INLINE DISPLAY 1.44" E30430 1 Preliminary note You will find instructions, technical data, approvals and further information using the QR code on the unit / packaging or at www.ifm.com. 1.1 Symbols used Requirement Instructions Reaction, result [...] Designation of keys, buttons or indications...
E30430 IO-Link INLINE DISPLAY 1.44" 2 Safety instructions • The device described is used in a system as subcomponent. – The system architect is responsible for the safety of the system. – The system architect undertakes to perform a risk assessment and to create documentation in accordance with legal and normative requirements to be provided to the operator and user of the system.
IO-Link INLINE DISPLAY 1.44" E30430 3 Intended use The IO-Link INLINE DISPLAY is used for indicating process values and the corresponding information of a connected IO-Link sensor. IO-Link sensor IO-Link INLINE DISPLAY IO-Link master Fig. 1: Example of a system integration...
IO-Link INLINE DISPLAY 1.44" 4 Getting started 4.1 Set-up No settings are necessary. In case the connected ifm device cannot be displayed: u Carry out the following steps: Load the device catalogue in moneo configure. Write the device catalogue to the display.
IO-Link INLINE DISPLAY 1.44" E30430 5 Function During operation, the device determines the process data that is cyclically transmitted by the sensor and indicates it on the display and as LED status.
E30430 IO-Link INLINE DISPLAY 1.44" 6 Installation u Insert the device into the system so that no mechanical forces are exerted on the housing. u For installation use the supplied accessories.
IO-Link INLINE DISPLAY 1.44" E30430 7 Electrical connection The device must be connected by a qualified electrician. The national and international regulations for the installation of electrical equipment must be adhered to. Supply voltage SELV, PELV according to the technical data sheet.
E30430 IO-Link INLINE DISPLAY 1.44" 8 Operating and display elements 1, 2: Indicator LEDs • LED 1 switching status OUT1 (is on when output 1 on the connected device is switched). • LED 2 switching status OUT2 (is on when output 2 on the connected device is switched).
IO-Link communication: ON, OFF: OFF: normal operation as passive display. ON: parameter setting or update of the device catalogue via the IODD tool www.ifm.com. When the device is started, this point is reset to OFF. Opening of the lower menu level DIS.
10.2 Updating the device catalogue 10.2.1 System requirements moneo version 1.9 or higher: u Connect the display to a PC via an IO-Link master, for example AL1060. Do not connect any device to the E30430 display. No controller (PLC) must be connected. IO-Link master Info...
Select the required IODD or the catalogue from the path. 10.2.3 Writing the device catalogue to the display Connect the display to an ifm AL1xxx IO-Link master and connect this master to a PC or laptop. u Start moneo configure u Carry out a network scan u Select the corresponding ifm AL1xxx IO-Link master or, if applicable, port.
E30430 IO-Link INLINE DISPLAY 1.44" u In the [Compatible IODDs] tab, select the device catalogue and confirm with [Import]. u Write the device catalogue to the display. w A note on the compatibility mode of the AL master is displayed. The port configuration of the master port is automatically reconfigured.
Page 15
IO-Link INLINE DISPLAY 1.44" E30430 u Load the settings back to the AL master.
<xxx> unknown ifm de- Device catalogue no longer up to date vice try catalogue u Device catalogue update: device update catalogue download for ifm devices at www.ifm.com invalid process da- The process data description does Error Process data recognition error...
12 Maintenance, repair and disposal The unit is maintenance-free. u Contact ifm in case of malfunction. u Do not open the housing as the unit does not contain any components which can be maintained by the user. The unit must only be repaired by the manufacturer.