Hitachi UX2 Series Basic Operation Manual page 56

Chapter 4. Ink and Makeup Replenishment
(2) Replenishment procedure
● Do not lift the cartridge bottle by holding the over cap.
Otherwise, the cartridge bottle may fall.
● Since the cartridge bottle contains an IC chip, avoid strong shock/electromagnetic waves or
liquid leakage.
1
Remove the over cap of the makeup cartridge bottle.
● After loosening the makeup cap, be sure to tighten it before setting the cartridge bottle.
Otherwise, the makeup may spill when the bottle is set.
● After removing the over cap, do not allow your finger, foreign matter, or dirt to get into the hole
of the makeup cap. Doing so could cause makeup leakage and equipment failure.
● Do not swap the cap between the ink cartridge bottle and the makeup cartridge bottle.
Otherwise, ink or makeup may spill.
The over cap is required only for storage.
It is unnecessary when refilling makeup.
Makeup cartridge
bottle
4-12
NOTE
NOTE
Over cap
Makeup cap