Hitachi UX2 Series Basic Operation Manual page 47

(2) Replenishment procedure
● Do not lift the cartridge bottle by holding the over cap.
Otherwise, the cartridge bottle may fall.
● Since the cartridge bottle contains an IC chip, avoid strong shock/electromagnetic waves or
liquid leakage.
1
Remove the over cap of the ink cartridge bottle.
● After loosening the ink cap, be sure to tighten it before setting the cartridge bottle.
Otherwise, the ink may spill when the bottle is set.
● After removing the over cap, do not allow your finger, foreign matter, or dirt to get into the hole
of the ink cap. Doing so could cause ink leakage and equipment failure.
● Do not swap the cap between the ink cartridge bottle and the makeup cartridge bottle.
Otherwise, ink or makeup may spill.
The over cap is required only for storage.
It is unnecessary when refilling ink.
Ink cartridge bottle
Chapter 4. Ink and Makeup Replenishment
NOTE
NOTE
Over cap
Ink cap
4-3