Yeswelder CT2050 Operator's Manual page 33

With External Air Compressor
Connection for Air Compressor Filter Regulator with an External Compressor
1
Loose the fixing nuts on the rear panel to install the bracket.
Ÿ
Place the air filter regulator on the bracket and fix it.
Ÿ
Connect the Inlet-Air In with the filter regulator outlet nozzle by an air tube and tighten it with a clamping band.
Ÿ
Connect the filter regulator inlet nozzle with an external air compressor by an air tube and tighten it with a clamping band.
Ÿ
Connect to the air compressor.
Ÿ
Pull up the gas pressure adjusting valve knob, then rotate left to reduce the outlet air pressure and right to increase the outlet air
Ÿ
pressure.
Pull down the pressure-reducing valve knob to fix it after the pressure is adjusted.
Ÿ
1
Loose the fixing nuts on the rear panel to install the bracket.
Ÿ
Place the air filter regulator on the bracket and fix it.
Ÿ
Connect the Inlet-Air In with the filter regulator outlet nozzle by an air tube and tighten it with a clamping band.
Ÿ
Connect the Inlet-Air Out with filter regulator inlet nozzle by an air tube and tighten it with a clamping band.
Ÿ
Connect to the air compressor.
Ÿ
Pull up the gas pressure adjusting valve knob, then rotate left to reduce the outlet air pressure and right to increase the outlet air
Ÿ
pressure.
Pull down the pressure-reducing valve knob to fix it after the pressure is adjusted.
Ÿ
Note:
Regularly drain the water inside the pressure-reducing valve.
When the water level reaches two-thirds of the water filter cup, water must be discharged; otherwise, the cut quality will be
affected.
2
2
3
3
30
4