Cisco Nexus 7018 Manual page 6

Hide thumbs Also See for Nexus 7018:

Attaching the Bottom-Support Rails

Make sure that the two bottom-support rails are level with one another. If they are not level, adjust the higher

Note

rail down to the level of the lower rail.

Figure 1: Positioning the Bottom-Support Rails

For the first and heaviest chassis installed in a rack, position

two bottom-support rails at the lowest RU on the rack.

Step 2

Use a Phillips torque screwdriver to screw in at least three (four if possible) M6 x 19 mm or 12-24 x 3/4 inch Phillips

screws on each end of each rail (using a total of 16 screws for both brackets) as shown in

Bottom-Support Rail to a Rack, on page

Installing a Cisco Nexus 7018 Chassis

Allow at least 43.75 inches (111.1 cm) (25 RU) for

each Cisco Nexus 7018 system.

7. Tighten each screw to a maximum of 40 in-lb [4.5 N·m]) of torque.

Installing a Cisco Nexus 7018 Chassis

Figure 2: Attaching a

Table of Contents