Cisco Nexus 7018 Manual page 27

Installing a Cisco Nexus 7018 Chassis
Figure 16: Attaching the Hinge Bracket to the Cable Management Frame and Chassis
1 Four M4x8 pan-head screws that fasten the hood
to the chassis.
Step 5
Tighten the four M4x8 screws that fasten the hinge bracket to the chassis to 11 to 15 in-lb (1.2 to 1.7 N·m).
Step 6 Tighten the four M4x8 screws that fasten the hinge bracket to the cable management frame to 11 to 15 in-lb (1.2 to 1.7
N·m).
Step 7 Fasten the four ball-point studs (51-5008-01), each one with a washer (49-0430-01), to the bottom portion of the chassis,
one stud by each corner of the air intake area as shown in
on page 28.
Installing the Front Door and Air Intake Frame
2 Four M4x8 pan-head screws that fasten the hood to the left and
right cable management assemblies.
Figure 17: Fastening Ball-Point Studs to the Air Intake Area,
Installing a Cisco Nexus 7018 Chassis
27