Axis D3110 User Manual page 9

AXIS D3110 Connectivity Hub
Configure your device
3. Go to MQTT subscriptions and add a subscription.
Enter the following information:
- Subscription filter: Motion
- Subscription type: Stateful
- QoS: 0, 1 or 2
4. Click Save.
Create a rule in the connectivity hub for MQTT subscriptions
1. Go to System > Events > Rules and add a rule.
2. Enter the following information:
- Name: Motion detected
- Condition: MQTT > Stateful
- Subscription filter: Motion
- Payload: On
- Action: I/O > Toggle I/O while the rule is active
- Port: I/O 1.
3. Click Save.
Open a lock when a button is pressed
This example explains how to connect a relay to the connectivity hub and how to set up an event to open a lock when someone
presses a button connected to the connectivity hub.
Prerequisites
• Connect a 2-wire cable (COM, NO) to the lock and to the relay connector on the connectivity hub.
• Connect a 2-wire cable (ground, I/O) to the button and to the I/O connector on the connectivity hub.
Configure the I/O ports in the connectivity hub
1. Go to System > Accessories.
2. Enter the following information in Port 1:
- Name: Button
- Direction: Input
- Normal state: Open circuit
3. Enter the following information in Port 9:
- Name: Lock
- Normal state: Open circuit
Create a rule in the connectivity hub
1. Go to System > Events and add a rule.
2. Enter the following information:
9