Axis D3110 User Manual page 8

AXIS D3110 Connectivity Hub
Configure your device
- Host: Broker IP address
- Client ID: For example Camera 1
- Protocol: The protocol the broker is set to
- Port: The port number used by the broker
- The broker Username and Password
2. Click Save and Connect.
Create two rules in the camera for MQTT publishing
1. Go to System > Events > Rules and add a rule.
2. Enter the following information:
- Name: Motion detected
- Condition: Applications > Motion alarm
- Action: MQTT > Send MQTT publish message
- Topic: Motion
- Payload: On
- QoS: 0, 1 or 2
3. Click Save.
4. Add another rule with the following information:
- Name: No motion
- Condition: Applications > Motion alarm
- Select Invert this condition.
- Action: MQTT > Send MQTT publish message
- Topic: Motion
- Payload: Off
- QoS: 0, 1 or 2
5. Click Save.
Set up the MQTT client in the connectivity hub
1. In the connectivity hub's device interface, go to System > MQTT > MQTT client > Broker and enter the following
information:
- Host: Broker IP address
- Client ID: Port 1
- Protocol: The protocol the broker is set to
- Port: The port number used by the broker
- Username and Password
2. Click Save and Connect.
8