Recordings - Axis D3110 User Manual

AXIS D3110 Connectivity Hub
The device interface
Listen and record
Click to listen.
Click to start a continuous recording of the live audio stream. Click again to stop the recording. If a recording is ongoing, it
will resume automatically after a reboot.
Note
You can only listen and record if input is turned on for the device. Go to Audio > Device settings to make sure that
input is turned on.
Click to show the storage that is configured for the device. To configure the storage you need to be logged in as an
administrator.
Audio mixer
Input
Ten Band Graphic Audio Equalizer: Turn on to adjust the level of different frequency bands within an audio signal.
Voice enhancement

Recordings

Click to filter the recordings.
From: Show recordings done after a certain point in time.
To: Show recordings up until a certain point in time.
Source : Show recordings based on source.
Event: Show recordings based on events.
Storage: Show recordings based on storage type.
Ongoing recordings: Show all ongoing recordings on the cameras.
Select to start a recording on the camera.
Choose which storage device to save to.
Select to stop a recording on the camera.
Triggered recordings will end both when manually stopped and when the camera is shut down.
Continuous recordings will continue until manually stopped. Even if the camera is shut down, the recording will continue
when the camera starts up again.
: Turn on to adjust the voice content in relation to other sounds.
13