Table of Contents
Advertisement
AXIS D3110 Connectivity Hub
Specifications
Amber/Red
Red
SD card slot
For SD card recommendations, see axis.com.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.
Buttons
Control button
The control button is used for:
•
Resetting the product to factory default settings. See Reset to factory default settings on page 37.
•
Connecting to a one-click cloud connection (O3C) service over the internet. To connect, press and hold the button
for about 3 seconds until the status LED flashes green.
Connectors
Network connector
RJ45 Ethernet connector.
Input: RJ45 Ethernet connector with Power over Ethernet (PoE).
Output: RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
•
Audio in – 3.5 mm input for a stereo microphone, or a line-in stereo signal.
•
Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
Audio output
1 Tip
Channel 1, unbalanced line, mono
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Flashes amber/red if network connection is unavailable or lost.
Flashes red for firmware upgrade failure.
2 Ring
Channel 1, unbalanced line, mono
34
3 Sleeve
Ground
Advertisement
Table of Contents
