Open Or Close The Battery Compartment Or Power Supply Compartment; Attach Or Remove The Seal - Siemens WTT568 Series Operating And Installation Instructions

Open the battery compartment or power supply compartment
1. Press the release tab of the cover inwards and simultaneously slide the cover to the right.
2. Lift off the cover.
Close the battery compartment or power supply compartment
1. Place the cover on the lower part to fit.
2. Snap the cover to the end position by pressing lightly.
Attach the seal
Note
Do not seal the WTT568../WTX568.. until it has been successfully put into operation!
1. Close the housing cover.
2. Insert the seal legs into the seal slot on the underside of the WTT568../WTX568...
(A) Seal slot
Remove the seal
1. Turn off the seal head with a slot screwdriver.
2. Open the housing.
3. Use the slot screwdriver to remove the seal residue from the seal slot.
– Place screwdriver on right side and eject seal remains to left side.
Checking the operating mode
You can check the mode at any time by pressing the function key briefly. The buzzer
generates a short tone and the display shows the current mode (here "normal").
To exit the display, briefly press the function key again or wait 6 seconds.
19.04.2022
A
Operation and use | EN
108