Table of Contents
Advertisement
Available languages
Available languages
9049032
3.
Set the desired cutting depth using the depth scale (P).
WARNING! To reduce the risk of serious injury, adjust the cutting depth to
just barely clear the workpiece and remove shavings, no more than 1/4 in.
below the thickness of the workpiece.
4.
Tighten the depth lever.
ADJUSTING THE BEVEL ANGLE
1.
Loosen the bevel lock knob (H) to allow the cutting angle to be adjusted.
2.
Set the desired cutting angle using the bevel scale (I).
3.
Tighten the bevel lock knob.
ADJUSTING THE FENCE
1.
Loosen the fence lock knob and slide the fence (M) to the desired
cutting width.
IMPORTANT! The ruler on the fence shows the approximate cutting width.
The fence can be removed completely if needed.
2.
Tighten the fence lock knob.
OPERATION
WARNING! To reduce the risk of serious injury, ensure the following
precautions are followed before operation: the guards are in place and in
proper working order; the depth lever, bevel lock knob and fence lock knob
are tightened.
1.
Hold the saw with one hand on the main handle (C) and the other hand
on the auxiliary handle (J).
2.
Align the saw along the cut line with the larger part of the workpiece
on the left side of the saw blade.
3.
Push in and hold the trigger lock (A) on either side, then press the
trigger (B).
4.
Allow the blade to reach full speed before contacting the workpiece.
IMPORTANT! Wood fibers can lift and tear when cutting across the grain.
Move the saw slowly to minimize any tearing.
7.
After completing the cut, release the trigger. Ensure that the lower
guard (E) closes immediately.
14
20V 6-1/2 in. Li-ion Cordless Circular Saw
For technical questions call 1-800-665-8685
V1.0
Advertisement
Table of Contents
