Adjusting The Depth; Adjusting The Bevel Angle - Power Fist 9049065 Manual

V1.0
INSTALL EXTERNAL BATTERY PACK
WARNING! Avoid unintentional starts by ensuring the trigger lock (J) is
engaged before installing the battery pack.
1. Check the battery power level before each use.
a. The battery is not fully charged out of the carton. Charge the
battery before first use.
2. Install the battery by aligning the rib on the battery with the groove
on the battery port (N) and push forward until the latch clicks.
3. Remove the battery by pushing the battery lock button and pulling the
battery free.
MOUNTING AND REMOVING THE BLADE
1. Hold the spindle lock button (O) down and use the supplied blade hex
key to loosen the blade bolt by rotating clockwise. Remove the bolt
and washer.
2. Lift the lower guard (J) using the lower guard handle (I). Remove the
old blade from the spindle.
3. Install the new blade. Ensure that the directional arrow on the blade is
pointing to the same direction as the arrow on the upper guard.
4. Hold the spindle lock button down and use the blade hex key to
replace the blade bolt and washer. Tighten securely.

ADJUSTING THE DEPTH

1. Set the shoe (H) flat against the edge of the workpiece.
2. Raise the depth lever (R) to allow the cutting depth to be adjusted.
3. Set the desired cutting depth using the depth scale (Q).
WARNING! To reduce the risk of serious injury, adjust the cutting depth to
just barely clear the workpiece and remove shavings, no more than 1/4 in.
below the thickness of the workpiece.
4. Tighten the depth lever.

ADJUSTING THE BEVEL ANGLE

1. Loosen the bevel lock knob (A) to allow the cutting angle to be adjusted.
2. Set the desired cutting angle using the bevel scale (B).
3. Tighten the bevel lock knob.
Visit www.princessauto.com for more information
20V 4-1/2 in. Li-ion Cordless Mini Circular Saw 9049065
13