Ryobi RPGENINV4K Manual page 7

4
1
Slide a washer onto the axle, then slide the axle into the wheel mounting hole.
Insert the hitch pin to secure the wheel and axle. The hitch pin should be pushed
into the axle until the center of the rest on top of the axle. Repeat the same
procedure for the second wheel.
8
1
2
Fill the fuel tank with fuel. Turn the the
fuel cap clockwise to close the fuel
tank.
NOTE: Do not allow the fuel tank to
overflow when filling. Fill to 25 mm (1")
below the top neck of the gas tank to
allow for fuel expansion.
2
4
9
1
3
Turn the start lever to the START
position. Pull the starter grip until the
engine runs.
NOTE: Do not allow the starter grip
to snap back after starting. Return it
gently to its original place.
5
3
Remove the pin release to unlock the
handle. Lift the handle, then reattach
the pin release to lock the handle in
place.
10
2
2
Allow the product to run for 15-30
seconds, then turn the lever to the RUN
position.
3
3
6
2
2
1
15-30s
7
Getting started