Ryobi RYi2000T Quick Start Manual

RYi2000T
DIGITAL INVERTER GENERATOR
WARNING:
Do not connect to a building's electri-
cal system unless the generator and transfer switch have
been properly installed and the electrical output has been
verified by a qualified electrician.
Typical Generator
Exhaust Port
Pointed away from
dwelling openings
988000-415
12-1-11 (REV:02)
WARNING:
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product.
Add engine lubricant. Refer to page 12 of the
1 1
operator's manual for more details.
Shown
NE PAS UTILISER D'ESSENCE E15 OU E85 DANS CET APPAREIL.
DO NOT RETURN TO THE STORE!
If you have any questions, please call: 1-800-860-4050
or visit our website at www.ryobitools.com
Product style and configuration may vary
QUICK START GUIDE
Add fuel. Refer to page 13 of the operator's manual for
2
more details.
.C
OI L
LO W
M
AL AR
US H
ON /P
TO R
OT EC
DC PR
DO NOT USE E15 OR E85 FUEL IN THIS UNIT.
IT IS A VIOLATION OF FEDERAL LAW AND
WILL DAMAGE THE UNIT AND VOID YOUR WARRANTY.
UNE TELLE UTILISATION REPRÉSENTE UNE VIOLATION
DE LA LOI FÉDÉRALE ET ENDOMMAGERA L'APPAREIL
ET ANNULERA LA GARANTIE.
NO UTILICE COMBUSTIBLES E15 O E85 EN ESTA UNIDAD.
ESTO CONSTITUYE UNA VIOLACIÓN A LA LEY FEDERAL,
DAÑARÁ LA UNIDAD Y ANULARÁ LA GARANTÍA.
.
3
C
E
OIL
LO W
ON E
SU RG R
EC TO
PR OT
Start the engine. Refer to page 13 of the operator's
manual for more details.
 Unplug all loads from the generator.
 Open the vent on the fuel cap (A).
 Put auto idle switch in the OFF position.
 Put the on/stop switch in the ON ( I ) position (B).
 Move the choke lever right to the START position (C).
 Pull the starter grip and rope (D) until the engine
runs (a maximum of 6 times).
 Allow the engine to run for 15 - 30 seconds, then
move the choke lever left to the RUN position (E).
A
LOW OIL
ON GE
SUR TOR
TEC
PRO
.C
OIL
LOW ALAR M
D
ON/P USH R
DC PROT ECTO
B
ON / ON /P
DC P DC P