Control Panel - Merlin WeatherDrive MR555MYQ Installation And Operating Instructions Manual

CONTROL PANEL

4
1. Terminal Block: used for external accessories (see chart below).
NOTE: The terminal block is weather protected by a rubber grommet.
When using external wiring, the cable holes can be punched through with a small screwdriver. These holes should be sealed
with silicon sealant in order to maintain the weather proof rating.
NO FUNCTION
1 Push button
2 Common
3 The Protector System
(IR Beams)
4 Accessory power
2. DN Button: used to drive the door DOWN.
3. UP Button: used to drive the door UP.
4. P Button: used to "PROGRAM" the DOOR LIMITS (see section 14).
5. S Button: used to "SAVE" and "DELETE" the "TRANSMITTERS" (see section 23).
6. Key Lock: used to lock the engage/disengage mechanisim for commercial applications
7. LEDs:
1. Program DOWN, and Diagnostic code indicator Number 1.
2. Program UP indicator.
3. Diagnostic code indicator Number 2.
8. Courtesy Light: turns on during operation and automatically turns off after a period of 3 minutes .
1
6
INTRODUCTION
COLOUR POLARITY
Red +ve
White -ve
TM Grey +ve
Green +ve
2
4 3 2 1
COMMENT
Dry contact input for push button wired wall controls.
Common terminal for push button, The Protector System
Beams) & accessory power.
The Protector System TM
24v dc 50 mA accessory output available for a universal
receiver.
3
4
1 1
2 2
DN DN UP UP P P
7
6
(IR Beams) input (pulsing type only
5
3 3
S S
8
TM (IR