Saved Positions Procedure; Prior To Start Up; Auger Barrel Rpm - MacDon FEEDSTORM D60 Operator's Manual

Saved Positions Procedure

Saved positions are an optional feature, providing the ability to program the actuators to
preferred configurations, to maximise effectiveness during harvest.
1. Move the actuators to the desired location.
2. Press the "M" button followed by a numbered button of choice.
3. The LED display will flash an "S", followed by the number selected. This indicates the
position has been saved.
To use a saved position during operation, press any of the numbered buttons and the
actuators will begin to move to the saved position.

PRIOR TO START UP

1. Ensure to grease all four lubrication points if required via the grease nipples, using
high temperature resistant grease.
o The Bearing of Parts 1A and 2A; two grease points.
o The Universal Joints, Part 7; two grease points.
2. Familiarise the operator with the actuators, including the operation and reset
procedures and the troubleshooting instructions, prior to harvesting.

AUGER BARREL RPM

• The recommended rotational speed of the auger barrels is to be operating in sync
with the draper belt speed. Note: the linear speed of both the draper belt and the
auger screw should be approximately the same, adjust the flow controller to
increase or decrease the auger RPM as required.
• If the auger begins to vibrate noticeably when operating at high RPM, excess of 300
RPM, reduce the operating RPM until this effect subsides.
28