Installation; Mechanical Fitment - MacDon FEEDSTORM D60 Operator's Manual

INSTALLATION

MECHANICAL FITMENT

These instructions refer to the diagram attached titled Mechanical Fitment Diagram, use for
reference upon installation.
Refer to the attached drawing UCA-MCD-ASM as support to the detailed instructions for
further information.
Note:
Installation process is minimum a two-person task.
•
• Ensure the header front is detached from the header and resting on
a flat stable surface for accessibility and safety during installation.
• Place boards over draper belt in locations requiring access for
installation, to protect the belts from damage and provide a stable
surface.
MOUNT BRACKETRY
STEP INSTRUCTION
1 Mark locations of fixture points on
the header front for Parts 1B, 2B, 8
and 9, as per attached drawing UCA-
MCD-ASM.
Bracket mounts, Parts 1B and 2B may
be preexisting on header front. If
preexisting, conduct a dimensional
check, to ensure the bracketry
spacing is correct as per the attached
drawing.
2 Align base plates of Parts 8 and 9 to
the flat plate profile of the header
front, on the marked locations
(centered to the 'fore and aft',
forwards and rearwards linear
motion actuators), as depicted in
drawing UCA-MCD-ASM.
Mark out plate profiles.
REFERENCE IMAGE
10