Advertisement
10
GB
FITTING THE GRILLES AND FAN BLADE
1. Remove the fan and grille nuts by turning the first of these clockwise and the second
anticlockwise. Fit the rear grille in the correct position (handle upwards) and tighten the nut
until the grille is held firmly (fig. 1).
2. Fit the fan blade on the shaft and firmly tighten the fan nut. TIP: Ensure that the motor
shaft´s pin is in the fan blade´s groove (fig. 2).
3.Undo the clips on the front grille and position it on the rear grille (align the locking-screw
holes). Do up the clips. Secure both grilles by fitting and tightening the locking screws and
nuts (fig. 3).
Screw
FUNCTIONS
Speed adjustment
Press the button for the desired fan speed.
à
0
Off
à
1
Low
à
2
Medium
3
à
High
Oscillation
To make the fan oscillate, push the oscillation control in. To stop oscillation, pull the oscilla-
tion control up.
Angle adjustment
Adjust the fan head to the desired angle by gripping the handle and pushing the fan grille
assembly carefully upwards or downwards.
Fan nut
Fig. 1
Tighten
Groove
Guide pin
Fan blade
Fig. 2
Screw
Fig. 3
© 2020, Elon Group AB. All rights reserved.
Advertisement
