Grill And Fan Blade Assembly; Operating Instructions; Cleaning - Canvac Q Air CGF1403V Use Instructions

GRILL & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out of the bag) and
the plastic nut counterclockwise to remove both of them. Fix the rear grill
to the motor then tighten the plastic nut again. (Fig. 7)
2. Slide the blade on to the shaft, and make sure the rotor shaft pin is
fitted into the groove in the blade. Turn the spinner counterclockwise to
tighten the blade. (Fig. 8)
3. Fasten the front grill and the rear grill with the grill clip and then
tighten the fan grill locking screw and nut. (Fig. 9)
Fig.7

OPERATING INSTRUCTIONS

1. Speed is controlled by the Piano switch:
0àOff 1àLow 2àMedium 3àHigh
2. To start/stop fan oscillation. Push down/pull up the clutch knob.
3.
To adjust the air flow upward or downward, push the grilles gently in the
desired direction.
4. The height of the fan can be adjusted by loosening the height
adjustment ring, carefully raising or lowering the fan and firmly
re-tightening the height adjustment ring.

CLEANING

1. Make sure the fan is unplugged from the power socket before
cleaning.
2. Plastic parts should be cleaned with a soft cloth moistened with a mild
detergent. Thoroughly remove the detergent film with a dry cloth.
© 2021, Elon Group AB. All rights reserved.
Fig.8 Fig.9
17