Table of Contents
Advertisement
maintenance
VALVE TRAY REPLACEMENT
PRIOR TO VALVE TRAY REPLACEMENT, ENSURE UNIT HAS COOLED
TO ROOM TEMPERATURE, ALL POWER IS DISCONNECTED AND
GAS SUPPLY IS TURNED OFF.
1. Remove faceplate, inner frame, glass door, front trim piece and inner
panels - see instructions in this manual.
2. Remove logs.
3. Remove burner side panels by lifting out as shown in Diagram 1.
Diagram 1 - Burner Side Panels
4. Remove enamel side panels by loosening the 2 screws (1 per side) in
locations noted and remove the 2 clips.
5. Remove front lip by removing 2 screws located on firebox floor.
6. Remove rear log tray by removing 3 screws as shown in Diagram 2 below.
Side Panel Screws
Diagram 2 - Side Panel, Front Lip & Log Tray
Screw Locations
|
60
Regency Ultimate ™ U900E-11 Gas Fireplace
Log Tray Screws
Front Lip Screws
7. Remove burner by removing 2 screws in locations shown below.
Diagram 3 - Burner Screw Locations
8. Remove valve tray by removing 14 screws in locations shown below.
Diagram 4 - Valve Tray Screw Locations
9. Lift out valve tray.
Diagram 5 - Valve Tray Removal
10.
Replace valve tray and reverse steps.
Advertisement
Table of Contents
