Table of Contents
Advertisement
11. PROGRAMMING PROCEDURES
11.3
INGREDIENT MESSAGE
Ingredient messages can be printed on a label with a maximum of 54 characters per line in small
letters or 32 characters per line using boldfaced small letters, by up to 38 lines.
NOTES:
Get user manuals:
See SafeManuals.com
Menu Page:
1
Item No.:
2
C
<MENU>
2
Page 1
NEXT
PLU
Enter the ingredient message
(Refer to Page 11-3.)
Pressing the
RECEIVE
calls data stored by pressing
SEND
the
key.
Pressing the
key
SEND
temporarily stores data into
the work buffer.
1. When no data is programmed for the PLU, ingredient cannot be set.
2. When a selected PLU is not stored in the PLU file, a "PLU NOT FOUND" error
occurs.
3. Once you exit this menu and enter again, data stored in the work buffer is cleared.
4. When there is no area to store ingredient data, a "MEMORY FULL" error occurs.
5. Different PLUs cannot use the same ingredient data. (PLU and ingredient data are in
pairs.)
Enter the PLU#
(max. 6 dig.)
or
ENTER
key
Any key
except Y
The memory file
is sorted when a
memory full error
occurs.
11-7
11.3 INGREDIENT MESSAGE
ENTER
C
PROG.
TEST
ESC.
Sorting
Y
Not Sorting
EM1-31064
<MENU>
Page 1
Main
<MENU>
Advertisement
Table of Contents
